11th International Conference on Network and Service Management
Barcelona, Spain - November 09-13, 2015

Camera-ready Paper Submission Instructions

1. General Information

Authors of accepted papers must guarantee that their paper will be presented at the conference/workshop. Every paper accepted at CNSM 2015, DCM or ManSDN/NFV must have an associated registration at the Author rate. At least one author of each accepted paper must be registered for the conference/workshop by September 10, 2015 in order for that paper to appear in the proceedings and to be scheduled for presentation. For a paper in which all authors are students, one student author must register at the Author rate. For authors presenting multiple papers, one author registration is valid for three papers at most.

2. Formatting and IEEE Xplore® Compliance

When your accepted paper (full paper, mini-conference paper, short paper, workshop paper) is presented, it will appear soon afterwards on IEEE Xplore® — the IEEE Digital Library — and it is important that your submitted PDF file meets the specification for IEEE Xplore®. Failing to submit an IEEE Xplore® compatible PDF file may result in the file not being included in the conference proceedings. Please refer to the IEEE document "Simplified Requirements for Creating PDF Files for IEEE Xplore®" for more information. We strongly recommend that all final submissions be created using the IEEE PDF eXpress™ service. The IEEE PDF eXpress™ service can convert your paper from a wide range of formats to IEEE Xplore®-compatible PDFs. The service is free of charge for CNSM 2015, DCM or ManSDN/NFV authors and can be accessed using the following information:

An online confirmation will be displayed and an email confirmation will be sent verifying your account setup.

Previous users of PDF eXpress need to follow the above steps, but should enter the same password that was used for previous conferences. Verify that your contact information is valid.

The following information is intended to guide you on formatting your final paper, ensuring your PDF file is IEEE Xplore® compliant.

2.1 Page Limit

The page limits are as follows:

Please address the suggestions raised by the reviewers to improve the quality of your paper and make sure to comply with all formatting requirements. Please note that it is not possible to purchase extra pages.

2.2 Templates

Please format your final submission using the guidelines provided in IEEE_conf_layout.pdf. The guidelines are implemented in IEEE templates. LaTex authors please verify you are using the following documentclass:


Only in case you are unable to use LaTex, other text processors may be used at your own risk. IEEE provides a template for Word in US-Letter size. Your final submission must follow all IEEE conference formatting requirements (e.g., font sizes, margins, and layout). Thus, check them really carefully.

Margins must be:

Copyright Notice:

Insert an appropriate copyright notice on the first page (bottom left) as follows:

        \placetextbox{.2}{0.055}{ 978-3-901882-77-7~\copyright~2015 IFIP}


Further important requirements:

Please note that you should prepare the final manuscript with no page numbering.

3. Paper Upload

Before uploading your paper, please:

This is very important because we will be using the information provided in EDAS/EasyChair to generate the final conference program and the table of contents for IEEE Xplore®. Please note that the abstract and title should be readable stand-alone and not contain any references or unexplained acronyms.

In case you need to modify the title or the abstract, you can do this through EDAS/EasyChair. Changes to the list of authors, allowed only under exceptional circumstances, have to be approved by TPC chairs. All the camera-ready papers have to be submitted via EDAS/EasyChair before September 20, 2015. EDAS/EasyChair will prevent you from uploading papers that do not comply with formatting checks. Please check all requirements carefully again if that happens. If you believe your paper is compliant and you are still prevented from uploading, please send your PDF eXpress-certified PDF file to the publication chair and ask for advice. Please always put your EDAS/EasyChair paper number in the subject line of email communication.

4. IFIP Copyright Form

Authors are required to transfer the copyright of their accepted papers to IFIP.

4.1 Authors of CNSM or SDN/NFV workshop

In this case you have to upload the form via EDAS. First, click here to get the IFIP copyright form. Read and fill it up adequately. Don’t forget to include the title of your work, the first and last names of all the authors, and then sign it. After getting the copyright ready, log onto EDAS and click on the copyright logo (©) of your accepted CNSM or Workshop paper. Update the signed copyright, following instructions on EDAS. Once you finish that process, EDAS will show the type and date of copyright submission on your paper page.

4.2 Authors of DCM workshop

In this case you have to download the form here, read and fill it adequately. Don’t forget to include the title of your work, the first and last names of all the authors, and then sign it and send the scanned copy to the DCM TPC Chair at shannon@woldconsulting.com

IMPORTANT NOTE: You must upload the camera-ready version of your paper and submit the IFIP copyright form no later than September 20, 2015. If you fail to comply, the paper will not be published in IEEE Xplore®.

5. Open Access

All presented CNSM 2015 papers and collocated workshop papers will appear as open access at the date of the conference and will be made available on the CNSM Web site. In case a paper is not presented during the corresponding conference or workshop, it will be removed instantly from the digital library.

6. Poster Presentations

Organization In-Cooperation With

Technical Co-Sponsors